|
It is currently 04 May 2024, 10:05
|
View unsolved topics | View unanswered posts
| Author |
Message |
Jump to forum Jump to topic |
| cplusplus |
|
Posted: 20 Apr 2024, 03:02
|
|
|
- Is ~$100 a good amount of cash to spend on this?
$100 total, yes.
- If the spindle motor is good in the D503, how difficult a job is it to replace these components?
I would say it is medium difficultly. Take care not to over disassemble. Do not break off the PCB lead that sticks out of the bottom of the metal spindle case. Replace the grip before you put it into the CLD-D704. |
|
 |
Jump to forum Jump to topic |
| grasshopper |
|
Posted: 23 Apr 2024, 21:58
|
|
|
The Spindle FG sensor also has to be carefully removed without breaking the plastic tabs. The plastic has become very brittle. Just finished a 703 and 704 for a member on here. The Spindles are wearing out quickly. He sent one parts 503 and that spindle was half locked. You can't use penetrating oil like on the older 701/702, etc. Those bearings worn out quickly new even on 503/703/704/99 and Karaoke models using same spindle. And the DVL's , 505, etc. 1995-1998. Spindles were low quality and seen many power Supplies burnt, because of the stress. I'm not sure if I even have enough spares to sell, still have a 703 that needs one replace... I've been backed up on service, because power Supplies need some recapping.
\../ |
|
|
|
Page 1 of 1 [ Search found 2 matches ]
|
Thanks list