| LaserDisc Database https://forum.lddb.com/ |
|
| Getting ac3 output from lc-v200 50 disc auto-changer https://forum.lddb.com/viewtopic.php?f=12&t=10063 |
Page 1 of 1 |
| Author: | willis [ 11 Oct 2021, 18:06 ] |
| Post subject: | Getting ac3 output from lc-v200 50 disc auto-changer |
I am considering attempting to modify my 50 disc changer to cover the full array of audio options found on laserdiscs. The changer currently only has the standard red/white stereo output. I would like to add ac3 rf as well as s/pdif. One nice feature of the changer is that the audio circuitry is located on a seperate PCB on the front door (connector cn138). The two players found inside send the raw rf signal to this board where a single DAC handles both players. My question for everyone is, what would you consider the cleanest approach to achieve adding ac3 and s/pdif. I would need to grab the signal post ic502, this chip switches the audio signal between the players depending upon what the co-v200 commands it to do. If anyone is so inclined to see the wiring diagram you can find it on page 66 of the manual. It's loaded to the database, I submitted it back in 2019. One thing to note, I have a Sony ep9es I plan to use as my pre-amp which will be dedicated to the changer. Any help would be much appreciated. |
|
| Page 1 of 1 | All times are UTC [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|