got a reply today. That sure was fast
It reads:
Quote:
Hi Kris,
Thanks for writing.
You may need to have a custom cable made for your particular setup.
Here is the pin out for the DIN Plug Connector. You would simply need a mini mono plug at the other end, only using the +12 VDC and ground connections for Power On function. Please refer to the pin out configuration on your new amplifier, but usually the tip of the mini jack will be your +12 VDC.
I hope this helps. Please let us know if you have any further questions and we will be glad to assist.
Have a great day.
KEVIN KENT
Field Support Engineer
Harman Luxury Audio Group, Lifestyle Division
8500 Balboa Blvd
Northridge, CA 91329
Phone: (888) 691-4171
Email:
csupport@harman.comWeb:
http://www.harman.com I am unable to post the drawing of the pinout for some reason, I'm not that patient with computers i'm afraid but it comes down to this...
Pin1 ground
Pin2 ground
Pin3 +12volt DC when Power ON
Pin4 No connection
Pin5 Trigger programmable