LaserDisc Database
https://forum.lddb.com/

should I get a new one?
https://forum.lddb.com/viewtopic.php?f=24&t=1350		 Page 2 of 2
Author:  rein-o [ 23 Mar 2013, 20:57 ]
Post subject:  Re: should I get a new one?
xtempo wrote:
I can't solder it so should I take it back to that place and tell them to solder the wires directly to the board or I suppose someone here could?

you can pickup an iron for very little and take a look at videos on youtube with how to do it.
you will save so much money.
Author:  xtempo [ 25 Mar 2013, 17:49 ]
Post subject:  Re: should I get a new one?
what if I solder the wires to the board and it still doesn't work? I wonder if that is the problem to start off with but when I opened it up last year it all looked fine. Anyone know where to send to get it worked on?
Author:  rein-o [ 26 Mar 2013, 02:48 ]
Post subject:  Re: should I get a new one?
xtempo wrote:
what if I solder the wires to the board and it still doesn't work? I wonder if that is the problem to start off with but when I opened it up last year it all looked fine. Anyone know where to send to get it worked on?

:think: if you solder the wires straight to the board and it's still not working then you have a major issue.

you can also just hold the wires with alligator clips, tape or something like that to see if it will work, just don't cross the wires.

as for repair?? you will have to find that or hopefully someone else will know.
good luck.
Author:  xtempo [ 27 Mar 2013, 19:32 ]
Post subject:  Re: should I get a new one?
I emailed Meridian just see what they would say about it and if they knew anything. so far I have not heard back.
Page 2 of 2 All times are UTC [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/