LaserDisc Database
https://forum.lddb.com/

DIY speaker feet marble coasters with instructions
https://forum.lddb.com/viewtopic.php?f=27&t=1660		 Page 1 of 1
Author:  invenio [ 05 Sep 2012, 14:48 ]
Post subject:  DIY speaker feet marble coasters with instructions
I use my Martin Logan Vantages on hard wood floors and I didn't want to ruin the floor with my Mapleshade Threaded Heaveyfeet brass spikes. I made some marble coasters for the speaker feet. Below is a picture. If you want to see the step by step instructions (and more pictures) you can visit the Step by Step Instruction Guide here.

Image
Author:  rein-o [ 05 Sep 2012, 17:52 ]
Post subject:  Re: DIY speaker feet marble coasters with instructions
do they work, or do you notice a difference?
i have carpet now and my speakers are on some hand made stands, but if i move i want to setup my
speakers well.

and i don't know what the floors will be next.
Author:  invenio [ 05 Sep 2012, 18:51 ]
Post subject:  Re: DIY speaker feet marble coasters with instructions
I have been able to put a little listening time on the new configuration and I would say that there is a minimal sonic improvement that I notice in the higher frequency range. The low end seems unaffected (as far as I can hear), but the harshness of some of the very high notes seem less, yet more detailed. I would say this is a "modest" improvement at best. It certainly does not degrade the sound. Considering this was a total of a $5 investment, I think it is well worth it. No it won't make $500 speakers sound like $5000 ones, but it will save your floors, look good, and hopefully improve the sound by a bit. I am very happy with the investment vs return ratio.
Page 1 of 1 All times are UTC [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/