It is currently 15 Dec 2019, 13:25

 Page 1 of 1 [ 1 post ] 
Author Message
 Post subject: Learning to perform alignments
PostPosted: 11 Mar 2019, 02:08 
Third post and above
Third post and above
User avatar

Joined: 19 Feb 2019, 03:37
Posts: 5
Location: United States
Has thanked: 0 time
Been thanked: 0 time
I am currently working on a Pioneer CLD 3390 that had a bad pickup and am trying to realign the replacement laser.

I do have a Tektronix 2246 oscilloscope, Pioneer test disc GGV 1069, as well as a service remote.

I also have the service manual for the CLD 3090 as well.

However, I have a couple of questions. First, where is the grating on the pickup? Looking at a spare pickup, I can see something deep inside but not sure if that's it.

Next, I see some of the adjustments require an AF Oscillator and resistors. Do I need those as well to properly perform the said alignments?

Lastly, is there anywhere can get an eccentric screwdriver?

I have been able to get the pickup to track the test disc by adjusting VR602 (TRKG Balance), but it is quite sluggish in chapter search.
Display posts from previous:  Sort by  
 Page 1 of 1 [ 1 post ] 

Who is online

Users browsing this forum: No registered users and 1 guest

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to: