LaserDisc Database https://forum.lddb.com/ |
|
CLD-97 Drive Gear? https://forum.lddb.com/viewtopic.php?f=30&t=8509 |
Page 1 of 1 |
Author: | ffrolvaag [ 13 Jul 2019, 16:20 ] |
Post subject: | CLD-97 Drive Gear? |
My CLD-97 now fails to engage the laser when loading a disc. Basically I can hear the laser assembly motor whirring after disc loading. Taking the cover off, I can see that the gear that the laser assembly uses to ride across the main track broke off and I can only find half the cog. The other half is probably stuck to somewhere inside. Does anyone know where I can get a replacement cog? If I have that the fix should be within my capabilities, and wouldn’t require a full laser assembly replacement. Did Pioneer use a standard track and gear assembly such that I could take a gear from a different player? Sorry if my description doesn’t make sense. I took a couple of photos, but can’t post them at the moment. Any help appreciated. I do have other players, but would hate to lose this one for losing a simple cog. If all else fails, I will try to have one 3D printed. |
Author: | krbahr [ 14 Jul 2019, 03:13 ] |
Post subject: | Re: CLD-97 Drive Gear? |
Buy a non-working CLD-2080 and hopefully that gear is good on that one and swap it onto your laser. |
Author: | ffrolvaag [ 16 Jul 2019, 01:27 ] |
Post subject: | Re: CLD-97 Drive Gear? |
krbahr wrote: Buy a non-working CLD-2080 and hopefully that gear is good on that one and swap it onto your laser. Thanks, I am working on acquiring one. If I can’t source one, I was able to determine it is a 14mm, 16 tooth, 38 pitch gear. It looks like it is possible to have one custom made, but would probably be relatively expensive for a single one. |
Author: | invenio [ 30 Jul 2019, 21:00 ] |
Post subject: | Re: CLD-97 Drive Gear? |
ffrolvaag wrote: krbahr wrote: Buy a non-working CLD-2080 and hopefully that gear is good on that one and swap it onto your laser. Thanks, I am working on acquiring one. If I can’t source one, I was able to determine it is a 14mm, 16 tooth, 38 pitch gear. It looks like it is possible to have one custom made, but would probably be relatively expensive for a single one. Maybe you can look into somebody 3D printing it. That should not be too expensive. |
Page 1 of 1 | All times are UTC [ DST ] |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |