krbahr wrote:
You have to check if the MHolder has broken pins that hold the movement gears which is a common problem with this unit and then if the assembly does not fully raise the load belt needs to be replaced.
I don't have the most amount of experience with M Holders, but from what I can see it looks fine. I think it's a given that the belt needs to be replaced, as the machine was manufactured October 1995. That being said, I don't think the load belt is causing the issue.
I've been observing the mechanism without the tray inside the machine. I've got to manually move the cam gear. By moving the cam gear, that should have raised the mechanism, but it didn't. There is a white gear that seems to lift the mechanism up, however it is very stiff and I can't move it all the way.
I'd also like to mention that the tray seems like it's getting physically stuck on the way out, and I have to pull hard to get it over those stuck gears to depress the stoppers to take the tray out.