LaserDisc Database
https://forum.lddb.com/

[CLD-150K] Lens on laser assembly doesn‘t focus
https://forum.lddb.com/viewtopic.php?f=53&t=10468
Page 2 of 2

Author:  krieg_der_sterne [ 13 Aug 2022, 22:23 ]
Post subject:  Re: Help with CLD-150K, lens on laser assembly doesn‘t focus

So, I noticed that at various components, I can measure up to 16 volt. That‘s not normal, is it? What would be the cause of it?

Aside from that I could still not locate where the error lies.

Author:  cplusplus [ 19 Aug 2022, 14:22 ]
Post subject:  Re: Help with CLD-150K, lens on laser assembly doesn‘t focus

krieg_der_sterne wrote:
So, I noticed that at various components, I can measure up to 16 volt. That‘s not normal, is it?

+14VDC and -14VDC is used.

Is the power supply putting out both +14VDC and -14VDC? If so, check voltages of pins 4 and 8 of IC802.

Author:  krieg_der_sterne [ 19 Aug 2022, 15:39 ]
Post subject:  Re: Help with CLD-150K, lens on laser assembly doesn‘t focus

It‘s a really tight space but I think I got it. I‘m measuring -0,13 volt.
(I measured from pin 4 to 8, that‘s what you meant, right?)

By the way, IC802 is directly connected to Focus Drive and Focus return, so it could be responsible for my first problem, but how is it related to the one I caused?
I mean, IC804 is responsible for Loading Motor Assembly and Carriage Motor Assembly. How likely is it that my shortcut grilled that one?

Author:  cplusplus [ 20 Aug 2022, 03:08 ]
Post subject:  Re: Help with CLD-150K, lens on laser assembly doesn‘t focus

Both IC802 and IC804 take in +/-14VDC. Check from pin to ground, not pin to pin.

Author:  krieg_der_sterne [ 22 Aug 2022, 14:54 ]
Post subject:  Re: Help with CLD-150K, lens on laser assembly doesn‘t focus

So on IC804 from each pin to ground it‘s never more than 2.44 volt. On IC802 Pin 4 and 8 to ground there are exactly 0.66 volt.

I also noticed that one part gets really hot really fast. It‘s the metall barrier below the power converter on the photo. The power converter stays relativly cool.

Attachments:
17AC77F3-8AC7-4E6A-9090-04E19B07063A.jpeg
17AC77F3-8AC7-4E6A-9090-04E19B07063A.jpeg [ 252.78 KiB | Viewed 526 times ]

Author:  cplusplus [ 30 Aug 2022, 12:21 ]
Post subject:  Re: [CLD-150K] Lens on laser assembly doesn‘t focus

That heat sink is normal to be warm, but should not burn your finger.

You just need to trace through voltages until they stop.

Page 2 of 2 All times are UTC [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/