This started with the pickup lens acting like a pogo stik..jumpimg up and down after a side change..I could hear the lens grinding against the edge of the disc and then under it..ripped the white plastic ring off..I replaced the assy..worked fine initially..then the unit began powering down after a minute or so and then after a few seconds..thought it was Capacitors..Tried replacing them and found that a few or more were loose..pulled the copper and tin up from the CB…I replaced it with a cld99 board ,which works,.didnt try it for butt a few minutes..the Pickup needs adjusting and I didnt want to fry everything with my ignorance…yea I know..coulda been too late…
After much reading here ,I got the impression that the only difference between the 99 and EAD was a 3D filter…from the picture below ,that obviously is not completely accurate..The 99 has 2a 120v ,the EAD is 2a 240v…The only thing I can see that is not the same on the EAD vs 99 internally is the digital outputs that are wired to the power board….My question is…Will I ruin the EAD using the 99 board?..and what is the added 120v for?..just the digital outputs?…how much could they possibly draw?…trying to repair the board seems to be over my soldering skill level(there are many)….the EAD continues to be an adventure….if I wanted that…Id re-enlist..lol.
The picture shows the 99 on top..the EAD ,you can see the physical differences and the 2 wires that are for the digital outputs.
TIA
| Attachments: |
|
IMG_2733.jpeg [ 193.15 KiB | Viewed 1036 times ] |