It is currently 06 Nov 2024, 08:50




 Page 1 of 1 [ 2 posts ] 
Author Message
 Post subject: [CLD-D503] Laser Assembly Getting Stuck
PostPosted: 30 Sep 2024, 14:25 
First post
First post
User avatar

Joined: 28 Sep 2024, 19:24
Posts: 1
Location: United States
Has thanked: 0 time
Been thanked: 0 time
I am a newbie so this might be an easy fix. When I insert the disk tray, the laser assembly pops up and then the laser slides towards the disk. However when it reaches relatively close to the center, it runs into a plastic arm which is labelled as "CD plate" part number VNL1576 in the manual. Here is a link to a video of it happening, as it is kind of hard to describe else wise. Thanks for any help! :D
Offline
 Profile  
 
 Post subject: Re: [CLD-D503] Laser Assembly Getting Stuck
PostPosted: 07 Oct 2024, 03:38 
Absolute fan
Absolute fan
User avatar

Joined: 10 May 2007, 03:12
Posts: 1550
Location: United States
Has thanked: 0 time
Been thanked: 354 times
There are a couple micro switches that the laser moves over that are on the bottom of the mechanical assembly, the one further away from the spindle motor is for the position to sense for LD's and the one closer to the spindle motor is for the position to sense for CD's. Your CD position micro Sensor is most likely bad.

No replacement parts available, need to get one from a parts unit.
Offline
 Profile  
 
Display posts from previous:  Sort by  
 Page 1 of 1 [ 2 posts ] 


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to: