LaserDisc Database
https://forum.lddb.com/

[CLD-99] Plays CDs but wont play LDs
https://forum.lddb.com/viewtopic.php?f=53&t=7847		 Page 1 of 1
Author:  Guest [ 30 May 2018, 21:44 ]
Post subject:  [CLD-99] Plays CDs but wont play LDs
Pioneer CLD-99 it play CDs but wont play LDs, It spins in the right direction for 3-5 seconds then it start to spin backwards , 5 seconds later it stops then P5 error code shows on display,This unit it seems to be brand new, at first it would shut off after 5 seconds , but after removed the R2 resistance close to the fuse it stays on
Author:  ldfan [ 30 May 2018, 23:19 ]
Post subject:  Re: Pioneer CLD-99 it play CDs but wont play LDs, It spins i
Here is a possible answer to your problem.....

https://groups.google.com/forum/#!topic/alt.video.laserdisc/Sd_RTQuRoEw
Author:  rein-o [ 30 May 2018, 23:40 ]
Post subject:  Re: Pioneer CLD-99 it play CDs but wont play LDs, It spins i
ldfan wrote:
Here is a possible answer to your problem.....

https://groups.google.com/forum/#!topic/alt.video.laserdisc/Sd_RTQuRoEw

Ah Kurtis, Thanks for always helping out :thumbup:
Author:  blam1 [ 31 May 2018, 20:07 ]
Post subject:  Re: [CLD-99] Plays CDs but wont play LDs
Listen carefully for any slipping between the disc and the spindle motor. If the disc doesn't come up to speed within a certain amount of time the player will shut down. The CLD-99 uses the same rubber "mat" as the CLD-D703 (VEB1237), so replace that if you hear any slipping. You might get some temporary relief by cleaning the mat (I've used packing tape to pull the gunk out of the rubber).

Of course, the newsgroup post above is another possibility, but no RF is a bit harder to fix than a slipping disc :)
Author:  admin [ 01 Jun 2018, 02:09 ]
Post subject:  Re: [CLD-99] Plays CDs but wont play LDs
blam1 wrote:
Listen carefully for any slipping between the disc and the spindle motor. If the disc doesn't come up to speed within a certain amount of time the player will shut down.


That's typically how I get a P5 error sometimes when the label on the disc is a little dusty or dirty and you can hear slippage noise from the Player, usually STOP/PLAY will work at the 2nd time.

But I also got a spare rubber mat in case this starts to happen a little too often.

Julien
Author:  blam1 [ 01 Jun 2018, 16:57 ]
Post subject:  Re: [CLD-99] Plays CDs but wont play LDs
admin wrote:
blam1 wrote:
Listen carefully for any slipping between the disc and the spindle motor. If the disc doesn't come up to speed within a certain amount of time the player will shut down.


That's typically how I get a P5 error sometimes when the label on the disc is a little dusty or dirty and you can hear slippage noise from the Player, usually STOP/PLAY will work at the 2nd time.

But I also got a spare rubber mat in case this starts to happen a little too often.

Julien


I found Mitsubishi discs to be among the worst for this slipping. They had a matte finish that was prone to clogging up the rubber "fingers" and compounding the problem on other discs.
Page 1 of 1 All times are UTC [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/