LaserDisc Database https://forum.lddb.com/ |
|
CLD-1070/980/V2400/etc Cracked Pickup Gear Rail https://forum.lddb.com/viewtopic.php?f=53&t=8611 |
Page 1 of 1 |
Author: | takeshi666 [ 02 Sep 2019, 21:59 ] |
Post subject: | Re: CLD-1070/980/V2400/etc Cracked Pickup Gear Rail |
Rather than gluing it at the broken part, have you tried constructing an additional support beam like the one next to it and gluing that on instead? |
Author: | cplusplus [ 04 Sep 2019, 03:03 ] |
Post subject: | Re: CLD-1070/980/V2400/etc Cracked Pickup Gear Rail |
Thats a better idea. I'll give it a try. |
Author: | rein-o [ 04 Sep 2019, 14:34 ] |
Post subject: | Re: CLD-1070/980/V2400/etc Cracked Pickup Gear Rail |
takeshi666 wrote: Rather than gluing it at the broken part, have you tried constructing an additional support beam like the one next to it and gluing that on instead? You could also just get an entire block of material to go across inside that section, this way you have 3 points of glue. Back sides and bottom. Also try to rough up that plastic a little as its waxy and always hard to glue. |
Author: | blam1 [ 04 Sep 2019, 19:12 ] |
Post subject: | Re: CLD-1070/980/V2400/etc Cracked Pickup Gear Rail |
Every single one of these I have seen with this design are all cracked in the exact same place. This rail is also used in the CLD-M series players. I've got to wonder if it's supposed to be this way for stress relief. If you get a lot of movement, it may be the pickup is binding along the rail. Try clearing off all the old lubricant and replacing it with new. |
Author: | cplusplus [ 05 Sep 2019, 22:25 ] |
Post subject: | Re: CLD-1070/980/V2400/etc Cracked Pickup Gear Rail |
Thanks for the suggestions. I'm now wondering if this is a flaw or not as well. |
Page 1 of 1 | All times are UTC [ DST ] |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |