LaserDisc Database
https://forum.lddb.com/

[HLD-X9] P5 error
https://forum.lddb.com/viewtopic.php?f=54&t=6819		 Page 1 of 1
Author:  kris [ 05 Jan 2017, 08:29 ]
Post subject:  [HLD-X9] P5 error
Anyone have any info on the P5 error displayed on the HLD-X9.
Any repair suggestions?
Author:  kencol [ 05 Jan 2017, 19:39 ]
Post subject:  Re: HLD-X9 error
Is the error on all discs or just Muse discs? I had an X9 popping a P5 error on Muse discs only and it turned out to be the Syps board was at fault.
Author:  kris [ 05 Jan 2017, 23:50 ]
Post subject:  Re: HLD-X9 error
Both type of discs show this error.... what could be the problem...? What board? :crazy:
Author:  kencol [ 06 Jan 2017, 01:04 ]
Post subject:  Re: HLD-X9 error
Mine was specific to Muse discs and it turned out the system power supply board was at fault. Your best bet is to ask Kurtis who can hopefully point you in the right direction. I think P5 is a spindle error? Kurtis will know more
Author:  krbahr [ 06 Jan 2017, 03:52 ]
Post subject:  Re: HLD-X9 error
Either spindle motor is not spinning up fast enough, this would either be the power supply or spindle motor, or the laser is bad either the laser itself or the logic on the top right board not properly driving the laser.
Author:  edwin240170 [ 06 Jan 2017, 13:21 ]
Post subject:  Re: HLD-X9 error
Maybe the test mode could bring more clarity, have a look at the service manual, P5 is indeed spindle speed can not be reached in 60 seconds, action is to open top to see what happens according manual...
Author:  edwin240170 [ 06 Jan 2017, 14:18 ]
Post subject:  Re: HLD-X9 error
Kris, two other points :
Is your power converter strong enough? I know spindle motor consumes a lot, if your down converter is weak it can not deliver, have experienced this myself with a US player.

Did you try a 20 cm disc, the spindle motor requires less power than for a 30 cm disc.
Page 1 of 1 All times are UTC [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/