|
It is currently 20 Apr 2024, 04:03
|
View unsolved topics | View unanswered posts
|
|
|
|
sressi
|
Post subject: Re: Pioneer DVL-700 FL OFF button problem Posted: 09 May 2021, 20:41 |
Third post and above |
|
|
Joined: 09 May 2021, 19:45 Posts: 4 Location: Uruguay Has thanked: 0 time Been thanked: 0 time
|
rein-o wrote: Open it and cut it out?
This is just how it works from what I read of your post but you seem to want it on all the time. Would have to open and find traces to figure out where it goes etc but you may cause more damage in the long run.
If it ain't broke don't fix. Thanks for the reply. Actually the correct behavior of the player is to have the display window always on. "FL OFF" button turns the display off and on again. The "on again" part is what is not working as expected. "FL OFF" button light is always on (always enabled) and no matter how many times I press the button I can't turn the display window permanently on again. The display stays on for a few seconds and goes off.
|
|
|
|
|
sressi
|
Post subject: Re: Pioneer DVL-700 FL OFF button problem Posted: 09 May 2021, 21:18 |
Third post and above |
|
|
Joined: 09 May 2021, 19:45 Posts: 4 Location: Uruguay Has thanked: 0 time Been thanked: 0 time
|
ldfan wrote: It's possible you may just have cold solder connection on the button itself.
The only way to know is to remove the front panel and have a look @ that area. Also, when you have it opened, take a voltmeter and follow the traces from the button back to the chip that controls it and look for more colder solder leads. And course, you just need a soldering iron to reflow the solder. Thanks! I'll give it a try and check for a cold solder connection.
|
|
|
|
|
|
|
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
|
|